Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

WSS 2382 ap 2332 not getting image

Status
Not open for further replies.

mats84

Vendor
Oct 13, 2011
21
AE
i have a WSS 2380 ver 4.1 along with 120 working 2330 APs.I removed a few APs and rearranged them in the property.After i remove and plug back the AP is getting an ip but the image is not pushed.Can someone help me.Its urgent.
 
Are the APs on the same VLAN as the controller? If not you need to have a DNS entry that will tell the AP the IP address of the controller.

You can try these commands also:

set dap x upgrade-firmware
set dap x force-image-download

Substitute the AP number for X.

If its on a different VLAN than the controller, make sure you have an entry in your internal DNS server with a name of wlan-switch that points to the IP address of the controller.



 
The APs and controller are in the same VLAN..i tried out the above commands n still the same issue.
 
Hi,

Did you try to delete them from your configuration and setting them up again and see what happens (clean ap configuration)?
Another solution could be to upgrade you WSS system (4.1 is outdated) and see if the AP's will install the new image. There where some issue in 4.x in regards to AP's failing to upgrade their image as I recall.

Goodluck
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top