WS-X5403

[peytbass]

Can anyone help establish what the problem may be on my two 5403's? I am trying to enable port2 2-3..as they are currently "inactive." After visiting the Cisco site to ensure that I have used the right commands...I am still unable to configure the balde properly. I have cleared the boards of all previous configurations. I am using a WS-X5509 Sup Engine. Please see the following outputs...

Console> (enable) sh port
Port Name Status Vlan Level Duplex Speed Type
----- ------------------ ---------- ---------- ------ ------ ----- ------------
1/1 notconnect 1 normal half 100 100BaseTX
1/2 notconnect 1 normal half 100 100BaseTX
2/1 notconnect 1 normal full 1000 No GBIC
2/2 inactive 1 normal full 1000 No GBIC
2/3 inactive 1 normal full 1000 No GBIC
4/1 notconnect 1 normal full 1000 No GBIC
4/2 inactive 1 normal full 1000 No GBIC
4/3 inactive 1 normal full 1000 No GBIC

Port Security Secure-Src-Addr Last-Src-Addr Shutdown Trap IfIndex
----- -------- ----------------- ----------------- -------- -------- -------
1/1 disabled No disabled 3
1/2 disabled No disabled 4

Port Trap IfIndex
----- -------- -------
2/1 disabled 10
2/2 disabled 11
2/3 disabled 12
4/1 disabled 16
4/2 disabled 17
4/3 disabled 18


Console> (enable) set port channel 2/1-3
Feature not supported on Module 2.
Console> (enable)

Console> (enable) set port enable 2/1-3
Ports 2/1-3 enabled.

Console> (enable) set port channel 2/1-3
Feature not supported on Module 2.
Console> (enable)

Thanks!

 

[jgercken]

Sounds like the blade isn't supported in your CLS version. I'd try upgrading and see if that helps.

-Jeff ----------------------------------------
Wasabi Pop Tarts! Write Kellogs today!

 

[byteya]

This is a 5509, right? With a Supervisor Engine II, only port 1 is active. With a Supervisor Engine III, all ports are active.

Also, in the Catalyst 5002 and 5000, only port 1 is active.

*J*

 

[peytbass]

Thank you very much the help on this issue. Problem resolved.

 

[MJewell]

If I remember correctly, port channels must be in groups of 2 or 4... I don't believe 3 is a valid port channel...

Mike

 

[jgercken]

Etherchannel groups can be assigned to between 2 and 8 ports but it will be active only on even pairs. If 3 are enabled, 2 will be active. If one fails, 2 will be active.
-Jeff ----------------------------------------
Wasabi Pop Tarts! Write Kellogs today!