Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Windows 98 Boot up

Status
Not open for further replies.

keihaz

Technical User
Nov 24, 2003
10
GB
Have a problem when booting up in Windows 98.
Windows Explorer is superimposed over desk top at completion of boot up. How do I stop this happening ?
 
My apologies to the forum. When I bootup, after my desktop appears "My Computer" superimposes itself (and not "Windows Explorer"). It causes no problem, but this is a new phenomenon which appeared after deleting hard ware and software, and is an annoyance.
 
If the problem started within the last 5 days, then press and hold the Ctrl key during startup, select 'Command prompt only' from the menu using the arrow keys, press Enter, at the C:\> prompt type scanreg /restore and press Enter, select a Registry that predates the problem and press Enter.

If that does not work or if the problem started more that 5 days ago, then reinstall Windows over itself.
 
never encountered this one yet, but maybe check ur Win.ini file by going to
Start>Run MSCONFIG
specifically under
[windows]
load=
run=

are these empty like above?...mine are

also look under
[Desktop_Shell]
Current=Win

and
[Programs]

Do you have a floppy in the drive.?
and do you a .pif file on your Desktop.?

TT4U

Notification:
These are just "my" thoughts....and should be carefully measured against other opinions....I try very hard to impart correct info at all times.
 
Message to SKI.

This problem was more than five days old, so I took your advice and reinstalled Windows 98. When it booted up again my desktop had gone almost to a "Safe Restart" - colours limited to 16 bit and display reduced to 640 x 480. Went into "add/remove" and removed Windows 98 and desktop returned to normal but still have the problem of "My computer" appearing over the desktop at bootup.
 
Message to TEKTIPPY4U.

Tried this one. Went into Win.ini and under [windows]
load= and run= were empty.

Could not find [Desktop_Shell] or Current=Win or [Progams].
No floppy in drive and where would I see .pif file ?
 
Hi, Have a look at this registry entry:
User Key: [HKEY_CURRENT_USER\Software\Microsoft\Windows\CurrentVersion\ExplorerBrowseNewProcess]
Name: BrowseNewProcess
Type: REG_SZ (String Value)
Value: Yes or No
If the value is yes set it to no and see if that helps....

If you're going through Hell...keep going... (Winston Churchill)
RocKeRFelLerZ
 
Hi RocKeRFelLerZ,

Tried regedit and altering BrowseNewProcess value to NO.
Unfortunately this hasn't cured the fault - looks as though I shall have to live with it and keep on cancelling "My Computer" each time I boot up.
 
Do me a favor....
On your desktop....if you have an Explorer shortcut....right click it and choose properties.....What's in the
"Start in" box and the
"Target" box??
post back

Go to Start>Programs....again right click Windows Explorer...choose properties
Whatcha got???

Go Start>Run MSCONFIG
Look in Startup Tab for a line that refers to Explorer.exe

Are you on a Network?

Right click any blank area on Desktop and .....is "View as web page" checked ??
If it is Uncheck it

If it's not choose "customize my desktop"....in "Internet Explorer Channel Bar" listed....if so check "View as web Page".....so you can then select and remove "ie channel bar"
and anything else listed there.

In an IE window choose Tools>Inet options>Advanced tab>.....look under "browser" area for "Show IE channel bar at startup" (if Active desktop is off)...



TT4U

Notification:
These are just "my" thoughts....and should be carefully measured against other opinions....I try very hard to impart correct info at all times.
 
When you installed Windows over itself, did it start in Safe mode, or did it start normally but in 640x480x16 and without 'My Computer' opening up?

If the latter, then all you may have to do is to reinstall your video card's drivers.
 
Do you close all windows......."before" you shutdown and do you shutdown through the Start Menu>Shutdown?
If not, try it.

R u on a network?

Do you have a floppy in the drive all the time?
if so, take it out

look here thread615-718252 (though slightly unrelated)for some more ideas of where to look for offending commands/settongs that may be making this happen.

From Start>Run MSCONFIG
...look in your Autoexec.bat file for a
PATH statement and post it

If it exists..it should almost always start with/contain;

PATH C:\;C:\Windows;C:\Windows\Command.........semi-colons separate full paths to apps/commands for batch files

Do you have TweakUI installed???
if so, under IE4 tab, look Active Desktop Enabled box



TT4U

Notification:
These are just "my" thoughts....and should be carefully measured against other opinions....I try very hard to impart correct info at all times.
 
Have solved the problem at long last. After much searching and eliminating, found that a programme "dRamatic" which is supposed to release memory was actually corrupted in some way and was initiating "My Computer". Removed the programme and then found that I hadn't enough memory to run Microsoft Word or anything else in the Office Suite. Deleted and reinstalled Office and now everything is working again. Still am not sure of the reason, but at least I'm back working again.
Many thanks to all members for your help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top