Who or What is calling the Ring over Page Station

[Delmar]

I am working on an option 11 that has an analog extension that is hooked up to the paging system for a night bell. (Whenever this extension is called it rings all over the plant).
It is only suppose to ring whenever the system is in night service, However over the last week it will sometimes ring during the day and it is confirmed that the system is definately not in night service when this happens.
I have a feeling that someone accidently discovered the extension number, or maybe someone put in the wrong autodial number.
But how do I find out what/ or who is calling it.
I know I can do a trac command, but I would have to execute the command while the call is in progress.

Is there any other way to do this

Thanks,
Delmar

 

[Reusser]

I would think you use call pickup to answer the bell at night. Have someone answer it when it rings during the day and ask who and what they dialed. Maybe the number is a DID and will need changed or it is a inhouse number and someone is dialing the ext.

If it is the same person dialing - you can tell them to stop or your break there fingers. if it is more than one you may have to change the number - and remember to enter the new number as a NIT_Data number in CDB.

 

[Crowd36]

Try using ENTC (Enhanced trace) in LD 80. Example syntax is:

entc 8 7 1015 (traces TN 8 7 for 10 hours 15 minutes)
gotr (starts trace)

You may have to set Multi_user to 'ON' in the OVLY section of LD 17