Which modules are required for a POTS line?

[phonebiz]

We are on CM 8.5 and normally install remote UCM sites with a 2911 router and a PRI. I have a request for a small site and would like to assign DIDs from another nearby location. If I want to add a single POTS line for 911 access, which module(s) do I need?

I would think my equipment list would be something like:
1 CISCO2911-V/K9 Voice Router Bundle
1 EM-HDA-6FXO 6-port FXO Module
1 HWIC-1DSU-T1 WAN Card

Do I need anything else, besides the Ethernet switch and IP phones?​

 

[phonebiz]

I finally found the right page on the Cisco site. It looks like a VIC2-2FXO
gives me two FXO ports and should do the job.

 

[gnrslash4life]

That's correct. You need FXO ports for POTS lines.

Certifications:
A+
Network+
CCENT
CCNA Voice