Where do you put in CODES??

[ChevyAlan]

My system rebooted (due to lack of PG&E power) - and I've lost all my configurations! Neat! I'm trying to rebuild the system and I don't know how to enable the PRI for usage. I have a PRI enabler code (8 digits) and a sticker that says "Key Code:" followed by a 24 digit number. I'm guessing this is it --- but I'm lost!

help! help! help! Thanks! Thanks! Thanks!!

-signed "my boss is going to hang me"

 

[ChevyAlan]

Hey! Better news!!
The 24 digit number is the correct one to enter (breaks into seperate 8digit numbers as I was typing it in). After that, go to HARDWARE, KSU, and CD1 --- then change it to PRI. Some of the settings under this may have to be modified in order match what the local telco is doing with it - but at least the lights are green again!

Now --- how do I get everyone to use this again????

-sign "boss might hang me in the morning"

 

[jerryreeve]

You will have to set up the whole prime and routing tables for dialing out. check out FAQ faq799-1646 on setting up the prime, routing tables and target lines. JerryReeve
Communications Systems Int'l
com-sys.com

 

[ChevyAlan]

All is fixed.... routes are built up, the phones are ringing, voicemail is listening and the hangman has been fired!!

Cheers!
-Mark