Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the unix command to default an S8300

Status
Not open for further replies.

NYSTECH

Vendor
May 9, 2008
1,512
US
Trying to default an S8300..

Have powere sustem down and have the CD in drive but it does not earase and reload..

Tried to shut down server fron web page and restart and have same issue..

I am thinking the CD I have may be bad.. The cd rom works on another system so I have rulled that out..

can someone tell me what the unix command to default through telnet..

Any info is appreciated..

ACS- IPOffice Implement
 
power it up with the cd in already.
telnet to it 192.11.13.6

on your pc:
start
run
telnet 192.11.13.6
and you will get the window you need
 
As stated above.. Loaded Cd in drive and powered up the system but it does not erase the 8300 like it should.. also tried shuting doen the 8300 though web interface and powering up like the DOCs say but that doeswn;t work either.. So I am looking for the UNIX command to erase the 8300 so I can load the CD...

ACS- IPOffice Implement
 
The cd will not erase the S8300. You have to choose to install or in this case re-install the software load.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top