Want to preface that this is really deep into PBX commands for me.
From what I found on this site and others, I was able to get the information below. After disabling and re-enabling, it goes back to DTI061.
Carrier said "Please check and verify the clocking on the PRI card in the PBX and advise. It should be set to ‘external’ in order to receive clocking from the serial WIC in our router."
My question is, how do I check what the PBX clocking is set to?
From what I found on this site and others, I was able to get the information below. After disabling and re-enabling, it goes back to DTI061.
Carrier said "Please check and verify the clocking on the PRI card in the PBX and advise. It should be set to ‘external’ in order to receive clocking from the serial WIC in our router."
My question is, how do I check what the PBX clocking is set to?
Code:
dis cc 0
.ssck 0
DSBL
IP DB PORT 1 DSBL
IP DB PORT 2 DSBL
IP DB PORT 3 DSBL
IP DB PORT 4 DSBL
CALL SERVER CLK SRC: CC
.enl cc 0
OK
.ssck 0
ENBL
CLOCK ACTIVE
CLOCK CONTROLLER - TRACK ON SLOT 1
PREF - 1
SREF - FREE RUN
AUTO SWREF CLK - ENBL
NO ERROR
IP DB PORT 1 DSBL
IP DB PORT 2 DSBL
IP DB PORT 3 DSBL
IP DB PORT 4 DSBL
CALL SERVER CLK SRC: CC
ssck 0
ENBL
CLOCK ACTIVE
CLOCK CONTROLLER -
DTI061
PREF - 1
SREF - FREE RUN
AUTO SWREF CLK - ENBLRRRRRR
IP DB PORT 1 DSBL
IP DB PORT 2 DSBL
IP DB PORT 3 DSBL
IP DB PORT 4 DSBL
CALL SERVER CLK SRC: CC
.
DTA015 1
.lcnt
PRI TRK LOOP 1
TRSH CNT:
BPV -000
SLIPD -281
SLIPR -000
CRC -000
LOSFA -003
OS_BPV -000
OS_LOSFA-003
OS_YEL -000