What command will show me the available dids in an ISDN Trounk group?

[rvallem]

I have an ISDN trunk group with 23 members (lines); I need to know which dids are available to use - to route the call to a particular extension number. What command(s) will show me what dids are availables?

 

[Tolson]

There is no command for that on the Avaya CM. You would need to get that information from the Telco that you are purchasing the service from. Once you know the range of DIDs that you hav purchased, you could look at the trunk group to see if you are inserting any digits in front of what they are sending to understand your extensions. The number inserted may also be in the "incoming call handling table" for a specific trunk table.

hope this helps.

 

[LoopbackJack]

First you will need to know your DID range from the carrier.

List extension-type will list your programmed extension values.

Rock on, be strong... SG
APDS UC, APDS CC, ACE IP Telephony