Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

What command will show me the available dids in an ISDN Trounk group?

Status
Not open for further replies.

rvallem

Technical User
Jun 9, 2009
2
US
I have an ISDN trunk group with 23 members (lines); I need to know which dids are available to use - to route the call to a particular extension number. What command(s) will show me what dids are availables?
 
There is no command for that on the Avaya CM. You would need to get that information from the Telco that you are purchasing the service from. Once you know the range of DIDs that you hav purchased, you could look at the trunk group to see if you are inserting any digits in front of what they are sending to understand your extensions. The number inserted may also be in the "incoming call handling table" for a specific trunk table.

hope this helps.
 
First you will need to know your DID range from the carrier.

List extension-type will list your programmed extension values.

Rock on, be strong... SG
APDS UC, APDS CC, ACE IP Telephony
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top