WAN over FR

[specialistacs]

I want connect 2 IPO 406V2 over a wan Port using a Framerelay ?

is it possible to do this ?

if yes is ther a specific configuration to implement.

I have a FR acces of 128KB/S

 

[kwing112000]

What type of handoff is it. Ethernet or something else.

Kevin Wing
ACA- Implement IP Office
Carousel Industries

 

[jamie77]

I belive if the FR CPE is kicking out X.21/V35 then this will plug into the serial WAN IPO LAN port.

Never tried it though.

C&P::
IP400 systems have a Wide Area Network (WAN) port that can be connected to a digital leased line service using either X.21 or V.35 interface at speeds up to 2048kbps. Point-to-Point protocol (PPP) is used over this link. The data within the call uses the Point-to-Point Protocol (PPP) which is used by the vast majority of manufacturers for linking routers. PPP support is essential if it is not the same manufacturer's equipment at each end of the link. Addition WAN ports can be added using up to two WAN3 10/100 external expansion modules. On Small Office Edition systems a single option WAN port card can be added. IP500 systems do not support this type of port.

Jamie Green

ACA:Implement - IP Office
ACS:Implement - IP Office

http://www.alliedcom.co.uk

Football is not a matter of life and death-It is far more important!!!!

 

[philetaylor]

Hi.

The IP Office (406) talks 'either' PPP or Frame Relay (Annex A, Annex D, LMI).

As long as the telco terminating equipment uses a supported interface (X.21 V.35 etc) then you should be OK 'but' I would probably buy a dedicated router for this task as it will be much more flexible and probably more stable!

Cheers

Phil