Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Waiting-for-Line problem 1

Status
Not open for further replies.

optionsleft

Vendor
Jan 13, 2007
124
EU
I am using IPO 500 (4.1)with T1 PRI . My problem is "wait-for-line" is kept on appearing on the phone display and giving busy tone after that. It happened even though 23 channels are in service-idle. Anyone who encounter this problem?



 
One site I had when I upgraded I had to add an entry in ARS

xxxxxxxxxxN
Dial
N

it doesn't make sense to me but it worked.
 
Double check your system short codes, ARS entries and line group assignments

Jamie Green

ACA:Implement - IP Office
ACS:Implement - IP Office


Football is not a matter of life and death-It is far more important!!!!
 
I have had this problem serveral times. Who is the carrier providing the PRI? Are you using NI2 or 5E?
 
If you have analog lines make sure they are set to a different line id.
 
I have short codes configured:
xxxxxxxxxxN
Dial
N

Verizon is the T1 provider and using NI2.

I also have analog trunks with different line ID. Still I encountered the problem.

mwooks
 
More info needed

What line group/ARS doesn that SC go to??

Jamie Green

ACA:Implement - IP Office
ACS:Implement - IP Office


Football is not a matter of life and death-It is far more important!!!!
 
With Verizon being the Carrier I would think that your problem is not the same as mine. 4.1.9 & 4.1.12 gave me problems with certain carriers switches when running NI2. We could receive incoming calls but not make outbound calls. We would get waiting for line. The quick fix was to change to 5E. This fixed the problem. Give it a try.
 
I just dealt with the same issue on IP500 with 4.1(12) and "new" PRI card.

I saw cause code 99 in my traces when calls did not go through. The CLEC tester said that they saw protocol errors on their soft switch when we tried to dial.

We got it working with either 5E or DMS for Switch Type under Line and PRI.

Good Luck,
Frank

Frank Robertshaw
The Phone Guy
Nashville, TN
 
I have had this happen on ramdom extn's and was due to the system returning "waiting for line" when an invalied number was sent to line. The system was running a low level of 4.1 software and we were advised by Avaya to upgrade, this resolved the issue.

I'm not sure for the sofware level and will check this tomorrow.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top