Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

VSU configured for messages to P.O.

Status
Not open for further replies.
Omissam

Omissam

Programmer
Jul 13, 2013
37
IT


Hello to all
how can I configure the VSU in order to record the day / night messages to enable incoming calls to P, O

Thank you
 
Sort by date Sort by votes
What do you mean by P,O? Operator?
If so, there are many ways to do this. Start with OPDNP, OPCTP etc. to get a clue of your conf. Also RA print commands would help...

fcpli
 
Upvote 0 Downvote




You should respond to a welcome announcement before sending the call to an operator.
Also, when the 'operator is night must take place on closing post offices.
How can I do using the VSU board?
Thank you




 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

etok
  • Question
MX-One TSW Force analog extension use specific route for external call
Replies
1
Views
214
Dolphintelecom
Dolphintelecom
utwo
  • Locked
  • Question
TLU83 for 7.5.0.1.1
Replies
3
Views
178
himdp
himdp
dll2003
  • Locked
  • Question
How to do a factory reset for DECT Aastra DT432?
Replies
2
Views
198
dll2003
dll2003
francescod
  • Locked
  • Question
Incoming calls on TLU79 connected to Aethra router BRI ports
Replies
4
Views
362
francescod
francescod
Carmelo Notaro
  • Locked
  • Question
Firmware R7H for the ELU34/1
Replies
1
Views
173
inlsp05
inlsp05

Part and Inventory Search

Sponsor

Back
Top