VPN Wag54g to RV-082

[foxyy]

Hello,
I try to connect site-to-site a wag54g to a Rv-082 and ... no result.

I use the green bow as client and every thing is fine to connect the rv-082 but I would like to avoid installing this soft on each computer.

That's why I try to connect router to router.

I'm using firmware 1.02.6_FR on the wag54g
and the config is :

IPsec enabled
PPTP enabled

local security group 192.168.1.0 - 255.255.255.0
remote security group : host
gateway : domain with Dyndns addres
3des
sha
key : auto
pfs : off
3600 sec

phase 1 :
agressif + username
3des
sha
1024 bits
28800 sec

phase 2:
3des
sha
1024 bits
3600 sec

but when i check the pfs tab, on the main screen it's on desabled and when i check advanced settings it's on enabled ...

this config is the same as in the green bow but here can't connect :-(

Could you help me ?

Thanks

 

[gtmoore]

Are both local networks 192.168.1.0 255.255.255.0 networks? If so they need to be different. When you say remote security group is host you mean the lan subnet of the rv082 and the remote security gateway is the wan address of the rv082? Also double check to make sure your preshared key is the same. Also did you view the logs to see the error you are receiving?

 

[foxyy]

wag54g :

192.168.1.1 - 255.255.255.0

rv082 :

192.168.168.1 - 255.255.255.0

in the wag54g i choose 'host' as security remote group so I'm sure i'll use the right settings (LAN)

the log file on the wag54g is :
2004-11-03 08:40:48 IKE[1] Tx >> AG_I1 : xxx.xxx.xxx.xxx SA, KE, Nonce, ID
2004-11-03 08:40:49 IKE[1] Rx << AG_R1 : xxx.xxx.xxx.xxx SA, KE, NONCE, ID, HASH
2004-11-03 08:40:49 IKE[1] ISAKMP SA CKI=[70a49386 b443021] CKR=[de0cb92e 1e3e7358]
2004-11-03 08:40:49 IKE[1] ISAKMP SA 3DES / SHA / PreShared / MODP_1024
2004-11-03 08:40:49 IKE[1] Tx >> AG_I2 : xxx.xxx.xxx.xxx HASH
2004-11-03 08:40:49 IKE[1] Tx >> QM_I1 : xxx.xxx.xxx.xxx HASH, SA, NONCE, KE, ID, ID

and I cann't connect ...