VPN config issue?

[matthijsNL]

I can't get Cisco PIX VPN client working with Cisco ASDM (http)?

Does somebody have a working configuration with only the "necessary CLI command's" for me?

I've the following PIX-model:

PIX# sh ver

Cisco PIX Security Appliance Software Version 7.0(4)
Device Manager Version 5.0(4)

Hardware: PIX-515E, 64 MB RAM, CPU Pentium II 433 MHz
Flash E28F128J3 @ 0xfff00000, 16MB

Licensed features for this platform:
Maximum Physical Interfaces : 3
Maximum VLANs : 10
Inside Hosts : Unlimited
Failover : Disabled
VPN-DES : Enabled
VPN-3DES-AES : Disabled
Cut-through Proxy : Enabled
Guards : Enabled
URL Filtering : Enabled
Security Contexts : 0
GTP/GPRS : Disabled
VPN Peers : Unlimited

This platform has a Restricted (R) license.

Kind regards Matthijs

 

[Supergrrover]

You have to enable the http server and then give it a access list for who you want to allow to connect. Defaul it nobody gets in except from the management port (port on the upper left as you look from behind.)

http server enable
http 192.168.1.0 255.255.255.0 management

Change the IP in the second string to a desired host or subnet and change the management to the interface you will be using.




Brent
Systems Engineer / Consultant
CCNP, CCSP