VPN between Linksys RV082 and Netgear FVS318 1

[richardp2]

We have a number of FVS318's at branch offices and remote home offices. We have established IPSec tunnel's in place between the FVS318's and a Netgear FVM318 located at the main office. (We used the FVM to have secure wireless at main office.) We would like to change the FVM318 for a Linksys RV082 (as we need a fail-over WAN connection) and then use the FVM318 as a secure wireless access point only.

Does anyone know of any white papers explaining setup of this configuration? As far as I know these devices are IPsec interoperable and should establish a secure tunnel with appropriate configuration. Any assistance would be appreciated.

 

[mattyb]

My office just got a RV082. Its a nice box. BUT, I have a Netgear 318 at my house. I can not Get my 318 to create a tunnel with the RV082. I Spent over 2 hours on the phone with Linksys. They could not get them to work. I have another tunnel on my 318 to another older model linksys, that tunnel works fine.

 

[kaigler]

COuld your roblem be the ip range on your box and the new RV082. I just read this on another site:

http://www.broadbandreports.com/forum/remark,9013301~mode=flat

good luck.

 

[kaigler]

Could your problem be the ip range on your box and the new RV082. I just read this on another site:

http://www.broadbandreports.com/forum/remark,9013301~mode=flat

good luck.