Hi-its been two years since I've touched a punch tool-i just switched to vonage. My router and d-mark are in two seperate areas. I guess I need to run a cat5 cable to one room from 66 block or run 2 cat3 to my vonage adapter. Or maybe I am making this way too hard. I have 2 lines with vonage. I have an ESI switch punched to a 66 block.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
voip question-wiring to 66 block
- Thread starter adh111681
- Start date
- Thread starter
- #2
Is there a phone jack where your router is located? IN that case you could wire the VOnage adaptor to that phone jack - BUT YOU MUST first disconnect the phone line at the real demarc.
Not a clean way to do it, but asssuming that the jacks in the house are wire up for two lines it should work.
Not a clean way to do it, but asssuming that the jacks in the house are wire up for two lines it should work.
- Status
