Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Voicemail Button not taking user into VM

Status
Not open for further replies.

colpot

Technical User
Jan 20, 2006
225
GB
I have a Customer who has just upgraded to MCD 8 PR3 and have a Nu-Point VM. When someone leaves a message the user presses the Envelope button and is prompted for the passcode and it works fine. If there is no message waiting and they press the envelope then they are prompted for a mailbox number. They enter their mailbox and its says invalid. If they dial the vm hunt group it works ok.
They insist it used to work on the previous version and it works on our house system which is MCD 6.0 SP3

Colpot
(Remember - If it aint broke - fix it till it is.)
 
Check the programming for the voicemail in the Call Coverage Services form

**********************************************
What's most important is that you realise ... There is no spoon.
 
Could be a stupid question, but what is prompting the user to press the VM button if it's not lighting?
Usually says NO MESSAGE in my case.

Not knowing is not a limitation of knowledge, it's a limitation of resource. Not sharing is a limitation of both.
 
Hi warlockcode - they are wanting to change their greeting on a daily basis.

Colpot
(Remember - If it aint broke - fix it till it is.)
 
I see, have they tried pressing the mailbox followed by * ?


Not knowing is not a limitation of knowledge, it's a limitation of resource. Not sharing is a limitation of both.
 
On a 3300, pressing the key when it is not lit will only follow the programming in the call coverage form.

If nothing is programmed in the call coverage form, nothing will happen.

Have you checked that programming as I suggested earlier?

**********************************************
What's most important is that you realise ... There is no spoon.
 
Hi kwbMitel
Apologies but I was away on hols and didn't update the ticket. Turns out the Call Coverage form had the VM Hunt group for another system in the cluster hence they were getting the invalid mailbox number.
Thanks for your help (as always!)

Colpot
(Remember - If it aint broke - fix it till it is.)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top