I'm having a problem with my voice mail system (new deployment) because calls are going to my voicemail rather than the voicemail of the called extension.
please find bellow the configuration of Coverage forwarding
SYSTEM PARAMETERS CALL COVERAGE / CALL FORWARDING
CALL COVERAGE/FORWARDING PARAMETERS
Local Cvg Subsequent Redirection/CFWD No Ans Interval (rings): 3
Off-Net Cvg Subsequent Redirection/CFWD No Ans Interval (rings): 3
Coverage - Caller Response Interval (seconds): 4
Threshold for Blocking Off-Net Redirection of Incoming Trunk Calls: 1
Location for Covered/Forwarded Calls: called VDN/Hunt Group Location: all
PGN/TN/COR for Covered and Forwarded Calls: caller
COR/FRL check for Covered and Forwarded Calls? n
QSIG/SIP Diverted Calls Follow Diverted to Party's Coverage Path? n
COVERAGE
Criteria for Logged Off/PSA/TTI Stations? n
Keep Held SBA at Coverage Point? y
External Coverage Treatment for Transferred Incoming Trunk Calls? n
Immediate Redirection on Receipt of PROGRESS Inband Information? n
Maintain SBA At Principal? y
QSIG VALU Coverage Overrides QSIG Diversion with Rerouting? n
Station Hunt Before Coverage? n
FORWARDING
Call Forward Override? n Coverage After Forwarding? y
SYSTEM PARAMETERS CALL COVERAGE / CALL FORWARDING
COVERAGE OF CALLS REDIRECTED OFF-NET (CCRON)
Coverage Of Calls Redirected Off-Net Enabled? y
Activate Answer Detection (Preserves SBA) On Final CCRON Cvg Point? y
Ignore Network Answer Supervision? n
Disable call classifier for CCRON over ISDN trunks? n
Disable call classifier for CCRON over SIP trunks? n
Sounds like you need to change the setting in SYSTEM PARAMETERS CALL COVERAGE / CALL FORWARDING. Try changing this setting from PGN/TN/COR for Covered and Forwarded Calls: caller to PGN/TN/COR for Covered and Forwarded Calls: called.
I just noticed you never setup your aar access code in the hunt group. You need to add that setting and add it to the aar table to route to session manager.
I would recommend following the Communication Manager/Session Manager integration doc as you are missing required configurations. One of which is the AAR and setting up your routing pattern/trunk groups correctly:
Note: On Page 40 it says to set the buffer size to 4096. This is incorrect and should be set to 8192. I just went through this with Avaya but they haven't updated their documentation.
Also, are you using port pooling on Avaya Messaging? Additional configuration is needed:
I did everything as the book says.
The problem persists, and the call cover is sent to my own mailbox (the calling party) rather than the called party's mailbox.
I double-checked every setting! I'm still not sure where the problem is!
Actually, the invite sent from SM to IX messaging was missing the history, so once I enabled "Support call history" on trunk group page 4, everything worked fine.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.