Patrickp1973
IS-IT--Management
I have 2 2600 series routers a 2691 and a 2621XM both with complete with T1 DSUs and 2 port FXO and 2 port FXS ports in each.
I have a working T1 data ppp connection between the routers and what I want to do is simply provide dial tone for transfers from one port to the other end to eliminate traditional TIE lines .. Ie dial PBX to PBX
Ie Point A FXO ----> Point B FXS and vice versa.
Seems very simplistic to do in theory but I am new to the Voice arena so I am just looking for a little help on this one..
Details
Point A IP 192.168.10.252 Point B 192.168.12.252
voice-port 1/0/0
cptone us
comfort noise
!
voice-port 1/0/1
!
voice-port 1/1/0
!
voice-port 1/1/1
!
!
!
!
!
dial-peer voice 5 voip
session target ipv4:192.168.10.100
ip qos dscp cs5 media
Any help would be appreciated
I have a working T1 data ppp connection between the routers and what I want to do is simply provide dial tone for transfers from one port to the other end to eliminate traditional TIE lines .. Ie dial PBX to PBX
Ie Point A FXO ----> Point B FXS and vice versa.
Seems very simplistic to do in theory but I am new to the Voice arena so I am just looking for a little help on this one..
Details
Point A IP 192.168.10.252 Point B 192.168.12.252
voice-port 1/0/0
cptone us
comfort noise
!
voice-port 1/0/1
!
voice-port 1/1/0
!
voice-port 1/1/1
!
!
!
!
!
dial-peer voice 5 voip
session target ipv4:192.168.10.100
ip qos dscp cs5 media
Any help would be appreciated