Vocera through PBX

[wiremantx]

We put a Vocera telephony server on a lineside T1.

Vocera cannot dial out to a local number. I did a Lis Trac for the TAC and I get this:


09:30:38 Calling party trunk-group 71 member 1 cid 0x17ad
09:30:38 Calling Number & Name NO-CPNumber NO-CPName
09:30:38 active trunk-group 71 member 1 cid 0x17ad
09:30:38 dial 9248 route:HNPA|ARS
09:30:38 term trunk-group 1 cid 0x17ad
09:30:38 dial 92487158 route:HNPA|ARS
09:30:38 route-pattern 1 preference 1 cid 0x17ad
09:30:38 seize trunk-group 1 member 155 cid 0x17ad
09:30:38 Setup digits 2487158
09:30:38 Calling Number & Name NO-CPNumber NO-CPName
09:30:38 denial event 1206: Req facility not implem D1=0x830047 D2=0x245
09:30:38 idle trunk-group 1 member 155 cid 0x17ad



Comparing it to when I dial out on a phone I get this:

time data

09:33:51 hold station 43837 cid 0xaa2
09:33:52 active station 43837 cid 0x1904
09:33:54 dial 9248 route:HNPA|ARS
09:33:54 term trunk-group 1 cid 0x1904
09:33:57 dial 92487158 route:HNPA|ARS
09:33:57 route-pattern 1 preference 1 cid 0x1904
09:33:57 seize trunk-group 1 member 153 cid 0x1904
09:33:57 Setup digits 2487158
09:33:57 Calling Number & Name 2107043837 NO-CPName
09:33:58 Proceed trunk-group 1 member 153 cid 0x1904
09:33:59 Alert trunk-group 1 member 153 cid 0x1904
09:34:06 idle station 43837 cid 0x1904
09:34:06 unhold station 43837 cid 0xaa2


They use the same COR so what is the top example telling me when it shows-> Calling Number & Name NO-CPNumber NO-CPName

 

[DontDeleteMeAgain]

looks like your vocera call is missing the area code going out

 

[gblucas]

I have not seen line side setup like this. In another life, I used to setup systems that would connect to PBXs for outbound dialing, and we always set them up as stations, using the station type DS1FD.

It looks like you have 2 TGs one trying to place a call out on another...

gblucas

 

[wiremantx]

it stops at the Denial event 1206.

Is this a problem with my PBX or with the server trying to dial out?