Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Virtual Unit Problem

Status
Not open for further replies.

OrionPax

Technical User
May 28, 2013
15
US
Good morning everyone. I am trying to find a virtual unit (tn) that is available on a branch site. I did the commands right, however I do not see any available. How can this be?
 
It may be that all of the units are in use on all of the virtual cards you have defined so far.

If this is the case, simply programming a new unit on an unused card will allow you to use the LUU or LUVU commands to generate good results.

Remember, you can use virtual cards 0 - 15 in your virtual loops, so for instance if you are currently using cards 0 - 10, you can just program a new unit on <loop> <shelf> 11 0, then when you issue the LUVU command against your loop, all of the remaining units on card 11 (1 - 31) would show up in the output.
 
Thanks allenmac. I will give it a try and report back.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top