Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Virtual Unit Problem
- Thread starter OrionPax
- Start date
It may be that all of the units are in use on all of the virtual cards you have defined so far.
If this is the case, simply programming a new unit on an unused card will allow you to use the LUU or LUVU commands to generate good results.
Remember, you can use virtual cards 0 - 15 in your virtual loops, so for instance if you are currently using cards 0 - 10, you can just program a new unit on <loop> <shelf> 11 0, then when you issue the LUVU command against your loop, all of the remaining units on card 11 (1 - 31) would show up in the output.
If this is the case, simply programming a new unit on an unused card will allow you to use the LUU or LUVU commands to generate good results.
Remember, you can use virtual cards 0 - 15 in your virtual loops, so for instance if you are currently using cards 0 - 10, you can just program a new unit on <loop> <shelf> 11 0, then when you issue the LUVU command against your loop, all of the remaining units on card 11 (1 - 31) would show up in the output.
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
