Can any explain how to set up video through the pbx. I currently have a didicated ISDN but the management would like to look at the quality of going thru the pbx. If someone could point me to the documentation or explain how to set up, it would be appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Video
- Thread starter s8700user
- Start date
- Thread starter
- #21
Unable to make or receive. Do i need to add a station in the pbx so that when a call comes in that it will pick it up.
change route-pattern 100 Page 1 of 3 SPE A
Pattern Number: 100
Grp. FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No. Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 50 0 3 n user
2: n user
3: n user
4: n user
5: n user
6: n user
BCC VALUE TSC CA-TSC ITC BCIE Service/Feature BAND No. Numbering LAR
0 1 2 3 4 W Request Dgts Format
Subaddress
1: y y y y y n n bothept none
change route-pattern 100 Page 1 of 3 SPE A
Pattern Number: 100
Grp. FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No. Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 50 0 3 n user
2: n user
3: n user
4: n user
5: n user
6: n user
BCC VALUE TSC CA-TSC ITC BCIE Service/Feature BAND No. Numbering LAR
0 1 2 3 4 W Request Dgts Format
Subaddress
1: y y y y y n n bothept none
phonegoober
Technical User
S8700User,
yes, you will need to setup a DID and a Data Module (Xport).
make sure the DID is on the incoming destination of your trunk group forms. Since you are on the 8700, i don't know for sure if you need the data module.
Make sure your NPA and inserted digits are on the route pattern, if you are doing that.
please copy/paste your DS1 form so i can review. In reading the thread,i am somewhat confused. Are you using the Adran or are you just going from the DS1 to the PRI brick in the Viewstation FX?
thx
yes, you will need to setup a DID and a Data Module (Xport).
make sure the DID is on the incoming destination of your trunk group forms. Since you are on the 8700, i don't know for sure if you need the data module.
Make sure your NPA and inserted digits are on the route pattern, if you are doing that.
please copy/paste your DS1 form so i can review. In reading the thread,i am somewhat confused. Are you using the Adran or are you just going from the DS1 to the PRI brick in the Viewstation FX?
thx
- Status
Similar threads
- Locked
- Question
- Locked
- Question