telepath9465
IS-IT--Management
I have a customer, he's trying to pull traffic data from the history. The traffic parameters are properly programmed in LD 2, and I've seen the traffic printout occur while I've been in the PBX. This of course occurs because trf is turned on for TTY 0 which is attached to the modem. This is an Option 11 Release 21.43. Another thing I've noticed, when I print AHST in LD 22, I don't see the traffic printouts in the history. Additionally there is a traffic buffer of as shown below.
REQ PRT
TYPE ADAN
ADAN HIST
SIZE 65000
USER MTC TRF SCH BUG
ADAN TRF
SIZE 65000
ADAN TTY 0
CARD 00
PORT 0
DES DIALUP
USER MTC TRF SCH
XSM NO
The goal is to print traffic data at the end of the day instead of logging in and printing traffic data in LD 2. Any help would be greatly appreciated... Also see example traffic data
.INVC 0 2
0000 TFC002
000
003 CO
00007 00007
0000002 00008
0000001 00001
00000 00000
00000
004 CO
00003 00003
0000000 00000
0000000 00000
00000 00000
00000
006 DID
00008 00008
0000001 00005
0000000 00000
00000 00000
00000
007 CO
00003 00003
0000000 00000
0000000 00000
00000 00000
00000
009 CO
00001 00001
0000000 00000
0000000 00000
00000 00000
00000
010 MUS
00001 00001
0000000 00000
0000000 00001
00000 00000
00000
REQ PRT
TYPE ADAN
ADAN HIST
SIZE 65000
USER MTC TRF SCH BUG
ADAN TRF
SIZE 65000
ADAN TTY 0
CARD 00
PORT 0
DES DIALUP
USER MTC TRF SCH
XSM NO
The goal is to print traffic data at the end of the day instead of logging in and printing traffic data in LD 2. Any help would be greatly appreciated... Also see example traffic data
.INVC 0 2
0000 TFC002
000
003 CO
00007 00007
0000002 00008
0000001 00001
00000 00000
00000
004 CO
00003 00003
0000000 00000
0000000 00000
00000 00000
00000
006 DID
00008 00008
0000001 00005
0000000 00000
00000 00000
00000
007 CO
00003 00003
0000000 00000
0000000 00000
00000 00000
00000
009 CO
00001 00001
0000000 00000
0000000 00000
00000 00000
00000
010 MUS
00001 00001
0000000 00000
0000000 00001
00000 00000
00000