I just got my HP Proliant DL380 G4 server last week. Along with the server, I have an Adaptec 39160 Ultra160 SCSI Card connect to a external HP DLT VS160 tape drive.
After installing the Driver & Arcserve 11.1, to my horror, the average throughput on this Server is less than 40MB/min!!! It is unacceptable!!!
The Spec of the server: 2 x 3.6GHz Xeon, 2GB RAM, RAID 5, etc The load on the server is still very low. But, why so slow? Running all kind of test on both tape drive, server look ok. I had also look at the Adaptec SCSI Card and can confirm that it speed is set to 160. But, still, unbelieveable slow!!!
My old server with only a Ultrawide SCSI with a DLT VS80 drive, running on Arcserve 6.0 give a better performance. Average Throughput is 200MB/Min. How come?
Any idea? Any suggestion? Please help.
Thank You
After installing the Driver & Arcserve 11.1, to my horror, the average throughput on this Server is less than 40MB/min!!! It is unacceptable!!!
The Spec of the server: 2 x 3.6GHz Xeon, 2GB RAM, RAID 5, etc The load on the server is still very low. But, why so slow? Running all kind of test on both tape drive, server look ok. I had also look at the Adaptec SCSI Card and can confirm that it speed is set to 160. But, still, unbelieveable slow!!!
My old server with only a Ultrawide SCSI with a DLT VS80 drive, running on Arcserve 6.0 give a better performance. Average Throughput is 200MB/Min. How come?
Any idea? Any suggestion? Please help.
Thank You