Hello,
it's connected on one channel to a Symmetrix 3830, using ED1032. Emulex got the EMC approved firmware, W2k drivers.
So far it's got connected, I got all the LUNs visible, mounted with drive letters, partitioned-formatted, read-write OK, working fine but VERY SLOW: 4 gigs takes more than 15 minutes to copy...
I tried to measure its speed with Nbench but it freezes always.
Settings under elxcfg (started with --emc switch, of course) exactly follow the corresponding pdf.
Any idea? Thanks!
it's connected on one channel to a Symmetrix 3830, using ED1032. Emulex got the EMC approved firmware, W2k drivers.
So far it's got connected, I got all the LUNs visible, mounted with drive letters, partitioned-formatted, read-write OK, working fine but VERY SLOW: 4 gigs takes more than 15 minutes to copy...
I tried to measure its speed with Nbench but it freezes always.
Settings under elxcfg (started with --emc switch, of course) exactly follow the corresponding pdf.
Any idea? Thanks!