Verifacation Please. Client and site 2 site at the same time

[quickconnect]

Currently I have a Cisco 1760 router doing a site-2-side VPN to our head end Cisco Concentrator. Nat-t is enabled...

I dont think this can be done but I want to get some opinions. I have a client that is sitting at the remote office end where the 1760 router sits and tries to launch our Cisco VPN Client version 4.02D with Nat-t is enabled using IPSec over UDP (NAT/PAT).
What happens is as soon as he launches the client from the inside network all site-2-site traffic stopped while the VPN Client is launched and in use. Once the VPN Client is disconnected the traffic on the site-2-site never starts flowing again I beleive is due to a routing confussion due to the vpn client being launched through the same interface. Is there a way to have our Site-2-Site and VPN client to site working at the same time through the same interface?

 

[quickconnect]

Anyone?

 

[ROUTERKID1]

VPN will block the other network connection on the LAN, Run an ip config when the user tries to connect to VPN to see if you still have an ip address. Try to ping the public ip address of the VPN device before you launch the Cisco vpn software. Tell me what you have at that point.

post up an ipconfig/all too if possible

 

[quickconnect]

I am Nat'ing on the inside... All inside traffic goes thought the tunnel.. No Split tunnel...

 

[quickconnect]

????????

 

[rnunley]

Hi connect,

I do not have an answer to your question, but have a question for you. I have been trying to setup a site to site between a 3000 concentrator and a few 1760's. Would you mind telling me how you did this?

thanks
Rob