Vector to forward calls to remote locations

[tgray1]

I know how to do this the standard way of remote-access and coverage-forwarding, etc.
I am also associating a DID which can be dialed from a remote location and utilze the vector below:
01 wait-time 1 secs hearing silence
02 collect 4 digits after announcement 2583 for none
03 goto step 5 if digits = 1111
04 goto step 6 if digits = 2222
05 route-to number *223905 with cov n if unconditionally
06 route-to number #223905 with cov n if unconditionally

*22 is the feature access code and 3905 is the extension you want to forward. When this is executed step 5 just hangs up instead of giving me dial tone where i should be able to put in the remote number 91 area code and number. Once that is complete I should get the 3 beep confirmation.
Thanks

 

[RTMCKEE]

What feature access code is that for?

Did you run a trace on the vector while trying to call it? What did the trace say?

rtmckee

CM 2.1.1
Prologix R9.05
Modular Messaging 1.1

 

[tgray1]

*22 is for enabling call forwarding
#22 disables

After further investigation I don't thing you can do what I was trying to accomplish by using a vector. *2 etc is DTMF and I do not think that is supported at this time in 3.1.2. Not sure about 4x or 5x versions.