VBA won't run on one database 2

[PaulBricker]

I have a db on the network that 2 of us use. On my pc, it runs fine. The AutoExec macro works and all the VBA event procedures work. On our Admin Assistants machine, the AutoExec Macro works but none of the VBA code executes. If I type something in her Immediate Window like
?Asc("m")
I get a message that her macros are disabled but in the Trust Center, our macro settings are both "Disable all macros with notice". As far as I can tell our settings are exactly the same. I have remapped her trust center to the appropriate folder (with subfolders checked) but no luck. If I enable her macros, the VBA works properly. The VBA in other db's we use runs fine on her machine. I'm just stumped about this.
I can provide any info needed, I just wanted to keep this initial post fairly small.

Thanks

Paul

 

[kjv1611]

Have you looked under:
Trusted Locations
??

It's in the same area - Trust Center Settings

 

[PaulBricker]

Thanks, yes, that's where I've remapped her paths to trusted locations. I finally got this just a few minutes ago. I wiped out all her locations, changed her Message bar in the trusted locations to 'Show message bar for all applications where content is blocked'. Then when I went back in I remapped all her trusted locations again. I think changing the Message Bar selection is what enabled the changes to actually take place.
Have a star.

Paul

 

[kjv1611]

The message bar isn't anything I've even bothered with to date. Useful info to keep in mind. Thanks.