Does anyone have experience with Valcom SIP Paging? I have a VIP-130AL, installed the 3rd Party IP licenses on version R10.1 It rings busy when I try to page to the extension. It seems to be due to it not registering. In Monitor it just continuously shows the message below. I used this following link as a setup guide.
192.168.11.250 is IPO
192.168.11.10 is Valcom Extension 241
21:14:33 1300569mS PRN: Monitor Status IP 500 V2 10.1.0.2.0 build 2
21:14:33 1300569mS PRN: LAW=U PRI=0, BRI=0, ALOG=4, VCOMP=10, MDM=0, WAN=0, MODU=0 LANM=0 CkSRC=0 VMAIL=1(VER=3 TYP=1) 1-X=0 CALLS=0(TOT=0)
21:14:40 1307076mS SIP Rx: UDP 192.168.11.10:5060 -> 192.168.11.250:5060
REGISTER sip:192.168.11.250:5060 SIP/2.0
To: 241 <sip:241@192.168.11.250:5060>
From: 241 <sip:241@192.168.11.250:5060>;tag=1804289383
Via: SIP/2.0/UDP 192.168.11.10:5060;branch=z9hG4bK-2084420925
Call-ID: 10061@192.168.11.10
Contact: 241 <sip:241@192.168.11.10:5060>;expires=3600
CSeq: 1060 REGISTER
Content-Length: 0
192.168.11.250 is IPO
192.168.11.10 is Valcom Extension 241
21:14:33 1300569mS PRN: Monitor Status IP 500 V2 10.1.0.2.0 build 2
21:14:33 1300569mS PRN: LAW=U PRI=0, BRI=0, ALOG=4, VCOMP=10, MDM=0, WAN=0, MODU=0 LANM=0 CkSRC=0 VMAIL=1(VER=3 TYP=1) 1-X=0 CALLS=0(TOT=0)
21:14:40 1307076mS SIP Rx: UDP 192.168.11.10:5060 -> 192.168.11.250:5060
REGISTER sip:192.168.11.250:5060 SIP/2.0
To: 241 <sip:241@192.168.11.250:5060>
From: 241 <sip:241@192.168.11.250:5060>;tag=1804289383
Via: SIP/2.0/UDP 192.168.11.10:5060;branch=z9hG4bK-2084420925
Call-ID: 10061@192.168.11.10
Contact: 241 <sip:241@192.168.11.10:5060>;expires=3600
CSeq: 1060 REGISTER
Content-Length: 0