Valcom SIP Paging

[clindsay1]

Does anyone have experience with Valcom SIP Paging? I have a VIP-130AL, installed the 3rd Party IP licenses on version R10.1 It rings busy when I try to page to the extension. It seems to be due to it not registering. In Monitor it just continuously shows the message below. I used this following link as a setup guide.

https://www.valcom.com/techsupport/config-docs/ValcomPgPro-IPO.pdf

192.168.11.250 is IPO
192.168.11.10 is Valcom Extension 241

21:14:33 1300569mS PRN: Monitor Status IP 500 V2 10.1.0.2.0 build 2
21:14:33 1300569mS PRN: LAW=U PRI=0, BRI=0, ALOG=4, VCOMP=10, MDM=0, WAN=0, MODU=0 LANM=0 CkSRC=0 VMAIL=1(VER=3 TYP=1) 1-X=0 CALLS=0(TOT=0)
21:14:40 1307076mS SIP Rx: UDP 192.168.11.10:5060 -> 192.168.11.250:5060
REGISTER sip:192.168.11.250:5060 SIP/2.0
To: 241 <sip:241@192.168.11.250:5060>
From: 241 <sip:241@192.168.11.250:5060>;tag=1804289383
Via: SIP/2.0/UDP 192.168.11.10:5060;branch=z9hG4bK-2084420925
Call-ID: 10061@192.168.11.10
Contact: 241 <sip:241@192.168.11.10:5060>;expires=3600
CSeq: 1060 REGISTER
Content-Length: 0

 

[lekappie]

Can you please provide more information thats coming back on this register from the ipo.

 

[Westi]

Set in the SIP extension the
3rd party Auto Answer to "Device Auto Answers"

Joe W.

FHandw, ACSS (SME)


"This is the end of the world, make sure to buy your T-shirt before it is too late"
Original expression of my daughter

 

[clindsay1]

I have set the "device auto answer" still gets a busy tone. I think the issue is that it is not registering. I never get anymore logs except what I had included above. I have enabled all SIP logging options in the monitor as well.

 

[lekappie]

This is an register problem. Try to configure it with a new extension and register is again.

Are you able to make an internal or external outgoing call? This should work without a valid registration.