Hi All
I have setup a new install of CCM 4.1 and i have a 2620 router with a NM-1v and vic-2fxo in it as the gateway to the PSTN. I have had the system running with no problems under CCM 3.3 MGCP but the only options i have under the gateway on CCM 4.1 is for VIC2-2FXO. I have set this up but the gateway is not registering. on the gateway i get the following under the
sh mgcp statistics
UDP pkts rx 25139, tx 131656
Unrecognized rx pkts 0, MGCP message parsing errors 0
Duplicate MGCP ack tx 0, Invalid versions count 0
CreateConn rx 0, successful 0, failed 0
DeleteConn rx 0, successful 0, failed 0
ModifyConn rx 0, successful 0, failed 0
DeleteConn tx 0, successful 0, failed 0
NotifyRequest rx 0, successful 0, failed 0
AuditConnection rx 0, successful 0, failed 0
AuditEndpoint rx 0, successful 0, failed 0
RestartInProgress tx 26468, successful 26468, failed 0
Notify tx 25797, successful 25797, failed 0
ACK tx 0, NACK tx 0
ACK rx 12571, NACK rx 12568
IP address based Call Agents statistics:
IP address 172.20.255.6, Total msg rx 25139,
successful 4, failed 12568
can i not use the vic-2fxo with ccm 4.1 or do i have to set it up as a h323 gateway? if so does anyone have a link on how this is done?
Thanks
Dave
I have setup a new install of CCM 4.1 and i have a 2620 router with a NM-1v and vic-2fxo in it as the gateway to the PSTN. I have had the system running with no problems under CCM 3.3 MGCP but the only options i have under the gateway on CCM 4.1 is for VIC2-2FXO. I have set this up but the gateway is not registering. on the gateway i get the following under the
sh mgcp statistics
UDP pkts rx 25139, tx 131656
Unrecognized rx pkts 0, MGCP message parsing errors 0
Duplicate MGCP ack tx 0, Invalid versions count 0
CreateConn rx 0, successful 0, failed 0
DeleteConn rx 0, successful 0, failed 0
ModifyConn rx 0, successful 0, failed 0
DeleteConn tx 0, successful 0, failed 0
NotifyRequest rx 0, successful 0, failed 0
AuditConnection rx 0, successful 0, failed 0
AuditEndpoint rx 0, successful 0, failed 0
RestartInProgress tx 26468, successful 26468, failed 0
Notify tx 25797, successful 25797, failed 0
ACK tx 0, NACK tx 0
ACK rx 12571, NACK rx 12568
IP address based Call Agents statistics:
IP address 172.20.255.6, Total msg rx 25139,
successful 4, failed 12568
can i not use the vic-2fxo with ccm 4.1 or do i have to set it up as a h323 gateway? if so does anyone have a link on how this is done?
Thanks
Dave