use remote PRI on BCM450 from BCM50 located in branch

[EugenB]

Hello

I have succesfully configured SIP trunking between two branches
using SIP trunks

now,I need to make PRI on BCM450 available for BCM50 users

any help will be appriciated


Thank you

 

[SNSSMIS]

Awesome, I read a previous post that detailed that scenerio. Are you using vmail and call pilot on the main BCM450?

 

[EugenB]

yes,but we also have VM on BCM50

do you have a link to the POST ?

 

[SNSSMIS]

this is not the one i was reading but close:

http://www.tek-tips.com/viewthread.cfm?qid=1577376

 

[SNSSMIS]

And this one:

http://www.tek-tips.com/viewthread.cfm?qid=1645950

 

[SNSSMIS]

there are several...

http://www.tek-tips.com/viewthread.cfm?qid=1608812

 

[SNSSMIS]

Another...

http://www.tek-tips.com/viewthread.cfm?qid=1645950

 

[EugenB]

Thank you

I was reading one of those but still no luck

 

[SNSSMIS]

I am hoping to simply hire a vendor that knows how to complete the task. Manage the system after the fact. Good luck.

 

[Rustymutt]

It's just routing. Set the routing up on the BCM50 to go out through the SIP channels.

 

[EugenB]

The routing is working.BCM50 can call internall extension but can not grab outside PRI - BlocB on BCM450

 

[telcodog]

Did you set up Remote access Packages on both sites?

 

[EugenB]

yes,I did

actually today made progress,I can dial 7 digits number like 310-BELL through PRI on BCM450 from BCM50

I think I know where to increase(Telephony->Dialing Plan-> Private Network) it but there max 7 ?

Thank you