usage coverage paths?

[bartfliet]

Hello,

I've been asked to do a cleanup of our system here, seeing as we're switching to the IP office.
In order to clean up the Coverage Paths, I would like to know if there is some way to use a command to know if a coverage path is used anywhere? I know you can do "list usage extention" to see where an extension is used, but I haven't been able to find such a command for Coverage path...

Any help would be appreciated, I would just need to see if the Coverage path is in use.

regards,
Bart

 

[Ronster]

display coverage sender-group xxx

_______________________________________________________________
I stay away from the telephone if at all possible.
Lee Trevino

 

[Ronster]

Also worth running the Audits under ASA "Fault & Performance" tab.


_______________________________________________________________
I stay away from the telephone if at all possible.
Lee Trevino

 

[bartfliet]

That does the trick, many thanks!

 

[bartfliet]

Is there a similar command to check if a Vector is used? As well as for Pick-up groups, hunt-groups and announcements?

 

[Ronster]

List usage hunt-group x

will show where a hunt group is referenced but is not usually very useful.

list usage extension XXXXX

using the hunt group extension is probably more useful.

list usage extension using a station extension will show if it is in a pickup-group, hunt-group etc.
list usage extension can also be used for announcement extensions to show which vector, VDN they are referenced in.

and there is also list usage vector xx to see what VDN, vector routes to a vector.

NB the most useful button on your ASA is the F5 "Help" button.
Type a command such as LIST then hit F5 to see what commands you can put next.

_______________________________________________________________
I stay away from the telephone if at all possible.
Lee Trevino