Urgent - Putting SW on to expansion module

[PlatinumGuy]

via the DTE port?

Anybody know how to do this?

ACA - IP Office Implement
ACS - IP Office Implement
ACE - IP Office Implement
ACI - IP Office Implement

 

[tlpeter]

here you go

thanks to intrigrant by the way




intrigrant (Programmer) 30 May 07 18:26
You need :
A config with such a module programmed ( create one off-line)
IP Office setup with a fixed IP Address and a TFTP address pointing to the PC which holds the binaries.
Thirth party tftp software ( i recommend 3COM, do a google on it )
AVAYA Manager on the PC with the TFTP ip address
Network access from the PC to the IP Office
Serial cable
Strong coffee

Power down the IP Office
Connect the module
Attach the serial cable between the module and PC
Power up IP Office
Open the config with Manager
Terminate Manager and start the TFTP server, set the default path to where the binary files are
Open hyperterminal 3800,8,N,1 and type AT, there should be a response back
Then type AT-X, the unit will reboot and ask IP Office for the binaries, IP Office will dowload the files from the TFTP server.
Drink your strong coffe an pray it will work, often it does not and you must retry a few times.
The reason to use a third party TFTP server is because Manager always says it cannot fine the file "avpots16.bin" while it is definetaly there.


ACA - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[tlpeter]

And ???
did you do the job ?
or wasn't it urgent enough


ACA - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[PlatinumGuy]

I didnt actually try this, we tried doing the AT commands again and it got its SW through the control unit in the usual manner.

Thanks.

ACA - IP Office Implement
ACS - IP Office Implement
ACE - IP Office Implement
ACI - IP Office Implement