Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Urgent NS700 system down after reboot

Status
Not open for further replies.

BobHLiton

IS-IT--Management
Aug 18, 2021
72
US
Incoming calls ring busy and outgoing calls get "Line not assigned".

This after I rebooted NS700 last night.

The configuration looks OK - settings to email alerts I made last night are still shown in WMC

Any idea what I should check first?

Thank you
 
I think I know what I did but not sure where the setting is I changed.

I changed the gateway to the voip service when I thought this was the gateway for for networking which was very slow.

Where is the routing for the voip gateway for telco?
 
Resolved: It was the main gateway for the network settings I needed to change back. Apparently it must point to the UniFi router installed by the service provider and *not* the default gateway of our LAN. <sigh>. At least I start early so most people didn't notice.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top