Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Upgrading MICS 2.0 to MICS 2.0 XC

Status
Not open for further replies.

BradleyComm

Programmer
Jan 11, 2007
10
US
Please accept my apology I've been reading thru the threads and cant find a specfic thread covering this same upgrade. Also i have been working on these systems for the past 8 years. Just never came accross a reason to preform a upgrade.

We have a cutomer with a MICS 2.0 all 6 ports on the fiber card are used. They want to add an addtional 0X16 module. So if I am correct in order for me to be able to add an addtional fiber card i need to upgrade to XC software. I felt upgrading from MICS 2.0 to MICS 2.0 XC would be the best thing to do to prevent vm issues. This is a new customer and i dont know much about the config so I really dont want to reprogram it.

Corporate sent me a USA-MICS-XC upgrade tool V.25.07 (which is a pc card) and a addtional nvram cartridge MICS 2.0 XC. Im confused because their is no slot in the MICS 2.0 nvram cartridge. What is the correct procedure?? The voicemail is a Nam. Also I have connected to the system via NRU and have a curent backup. Thank you.

Current Software MICS 2.0 NT7B72FG-93
New Software MICS 2.0 XC NTB72FF-93
Upgrade tool USA-MICS-XC Upgrade tool NT7B64CL
NAM VM 3.0.10A
 
The upgrade tool is for upgrading to MICS 4.0 and higher. To do the upgrade you speak of requires little more than back-up, power off, change software cartridges and re-boot. This may or may not change your DNs from 2 to 3, or 3 to 4 digits. Nothing should change regarding the programming, but you will have a current back-up. Verify the system is complete, then power down and insert the 2nd 6-port expansion card, and re-boot. Then back-up again.Remember, you're working on 15 year old software and all the hardware is manufacturer discontinued. If it all goes south the back-up could be your best friend
 
I should also mention that the system has copper dids and the extensions are already 4 digits. If I understand what you are telling me, the programing is stored in the cabinet not the software cartridge. Thats why I should not lose the programming by switching the software cartridge. Is that correct any thing else I should know. Thanks for the help.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top