Is it just me or does everyone get their control units with outdated software? I have yet to install a Small Office Edition and I opened it up and hooked up and found the installed software is 2.0.16. So that pretty much tells me that this unit has been sitting in a warehouse for about what...3 or 4 years? Well anyway the question is do I treat the upgrade to 3.1.56 just as an upgrade or do I need to do the whole 2.0(99) then to a 3.0 version and then to 3.0(99) and then to 3.1.56. I looked around for info on upgrading but looks like its just for the discontinued 403 that needed all the loader upgrades. Just want to make sure about the steps before I jump into it.
Thanks gents, and ladies!
Bill
Thanks gents, and ladies!
Bill