You need to have an OrderPro run on your system. This will identify any cards that are of a vntage that is not supported. Your distributir will do this for you.
I bought a 4.5 processor already programmed with my uploaded data but i cannot get into the switch via either core j21 or j25. it boots up goes through procedure i just cant get into programming. I have tried several terminals
on option 61 any clues
What is your processor type. P4 P2 or 68060? If it is a p4 check your cable from Com1 and see if it is the correct one connected to j25. I believe the aa is J25 to com1 and ba is j21 to com2.
Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.
The latest survey shows that 3 out of 4 people make up 75% of the population.
The original point and click interface was a Smith & Wesson.
Red meat is not bad for you, it is the green fuzzy meat that is bad.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.