Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

UPAM

Status
Not open for further replies.

Bibbyboy

Programmer
Jan 26, 2009
70
US
I have a UPAM that I am trying to use to work with a Bogen Paging System and I am getting a fast busy when I try to go through a line port on the IP500, and a slow busy when I try to go through a station port. I made the voltage 24 and 48, other then putting the phone system on the input t/r, and the paging system on the t/r theres really nothing else to configure except those switches which are correct...something on the phone system I might be missing? *80 is the paging shortcode, Dial, and line group of Line ID, for station= dial paging, and ext. number.
 
Call Forwarding or DND turned on? Try *00 on the port or thru the Manager.

Avaya_Red.gif

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________
 
All that is correct, however under the telephony tab I do see the offhook station checkbox, should that be checked or not checked?
 
when using a trunk dial page wont work. change to just dial

Kevin Wing
ACS- Implement IP Office
ACA- Implement IP Office
Carousel Industries
 
I never had much luck with a UPAM on an IP Office. It is always the 600 ohm thing that leads to a fast busy.

I now use the Valcom 200 or 2001 for my installations.

Frank
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top