Unprogrammed DIDs going to DN

[atascoman]

Hello,

BCM200 3.7, I have some DID numbers that are not programmed on target lines that are ringing on one of the DNs. I looked at the target lines that were programmed, and this DN is set as the control set.

Is there a global setting where I can change this. Not sure how this one DN got setup as the prime/control set. It's not the first in the range or anything.

 

[Deweyhumbolt]

It's more likely the Prime Set. If you changed the DN, it would change every Target Line, but still be the same set. You need to change it individually.

You could also switch the jumper with the DN you want to be the Prime Set and then use Change DNs to move it back.

Adversity is Opportunity

 

[SupportDude]

Dewey is right on the money.
Change your prime set.

-SD-

http://www.mysupportguy.net