unkown IP adress in SCN Network Status

[groej]

Hi,

I always find in IPO Server Edition systems in SCN Network Status IP address that neither fit to the system or are not programmed in the system. Funny is that it is always the same IP address and if only with the IPO500v2 devices is to be found. These can not be found in the primary or secondary server. If you export the config of the device and look for the IP address in it, it is not to be found. The screenshot is from an IPO Select R11 FP4 SP1.

Does anyone know from other systems or does anyone know where they come from?

The IP address should come from Australia. It can not be a hack or something like that.

Thanks for coming ideas.

 

[derfloh]

With WebSocket only one open TCP port is needed for a SCN connection. Are you sure that system is not reachable over the internet?

IP Office remote service

https://www.fwilke.com/home

Fixed price SIP trunk configuration:

https://www.fwilke.com/en/ip-office-sip-trunk-en/

CLI based cale blocking:

https://blog.fwilke.com/ip-office-block-calls-from-specific-cli/

SCN fallback over PSTN:

https://blog.fwilke.com/ip-office-scn-fallback/

 

[groej]

Hi,

the IPO500v2 are in other locations. There are no port diversions on the IPO's. If I disable this IP address in the firewall, the IP remains visible under SCN Network Status. The IPO's are only accessible via the VPN site networking.

If one looks in the monitor under TCP stream one does not find the address either.