I've inherited a G3 v12 pbx and we're in the process of migrating off of it. I'm looking into either scripting or scheduling some operations. The 'clear amw all [ext]' and 'rem station [ext]' commands work fine, but the 'change uniform-dialplan [ext]' command is causing me some trouble because it then opens a tabular display and I have to move the cursor to the next open slot in that table.
I'm wondering if there's either a way to schedule the uniform-dialplan changes via a csv file or something. ...or... With Cisco CM, I would define a pattern of say 1xxx which would be a less explicit match than say x1001. So if x1001 and x1003 are defined and assigned to phones, calls to those numbers would ring the phones but calls to x1002 would follow whatever logic was associated with the 1xxx route pattern. Is there a way to configure the uniform-dialplan like that?
thanks,
will
I'm wondering if there's either a way to schedule the uniform-dialplan changes via a csv file or something. ...or... With Cisco CM, I would define a pattern of say 1xxx which would be a less explicit match than say x1001. So if x1001 and x1003 are defined and assigned to phones, calls to those numbers would ring the phones but calls to x1002 would follow whatever logic was associated with the 1xxx route pattern. Is there a way to configure the uniform-dialplan like that?
thanks,
will