Unified Communications Module U110 CM

[alanroseman]

Hi Folks,

I have a brand new IP Office 500 R8.0 with a Unified Communications Module Installed.

The IP Office is at 192.168.1.151

Docs tell me the module can be / is at an internal address i.e.: 169.254.0.2. Which it is when connecting to the IP Office using the Manager.

I can browse to the IP Office at the IP 192.168.1.151, and even see the Comm Module there.

When I try to browse to the comm module 192.168.1.151:7070 I get to the login, but it will not accept the default username and password!

I've lost the better part of the afternoon attempting to login and configure the module.

Anyone have any idea about resetting the comm module while retaining the VP Pro software installed there???

Any help would be much appreciated.

 

[tlpeter]

Hi Alan,

Did you try

Administrator
Administrator

Or did you try

webcontrol
web

When you first install the UCM then it has the same IP address as the IPO but you will need to change that.
The 169 address can not be used and i only for internal communication between the IPO and the UCM so do not change that.

BAZINGA!

I'm not insane, my mother had me tested!