I'm new to the Server environment. This is probably a newb question but i can't figure it out.
I had setup the server to launch an application on connection of a remote client. It would launch the application but if i didn't have the Username and password i couldn't connect to the server at all. I don't remember how i set up the connection or where i go to do this. I have disabled the VPN in routing and remote connections. I uninstalled the application and removed it. Now i am given an error upon the connection stating that the path doesn't exist and i cannot connect to the server remotely. Is there a way to reset the settings or can anyone help as to where i might be able to change the configuration to stop looking for the application when i try and remotely connect?? thanks!!!
I had setup the server to launch an application on connection of a remote client. It would launch the application but if i didn't have the Username and password i couldn't connect to the server at all. I don't remember how i set up the connection or where i go to do this. I have disabled the VPN in routing and remote connections. I uninstalled the application and removed it. Now i am given an error upon the connection stating that the path doesn't exist and i cannot connect to the server remotely. Is there a way to reset the settings or can anyone help as to where i might be able to change the configuration to stop looking for the application when i try and remotely connect?? thanks!!!
