one of my resources failed to start on Node 1 and so i was able to fix that issue. i had to disconnect my 2 NICs that's connected to the public and failover and plug into a router to make the NIC look active rather than disconnected so that Cluster will not fail.
i have been trying to move my Node 1 group to Node B but it kept coming up with Error ID: 5005 (unable to move the group). i checked all the ownership of the resources and it has the proper Nodes listed. the Cluster wasn't in the middle of transfering resources, nor is Cluster Service paused, or stoped on both Node 1 and 2. the only thing i can think of is because the public NIC can not locate the DC where both Nodes are plugged into an isolated router to make the NICs look alive. the funny thing is that i can move Cluster Group between Node 1 and 2, but not my other two groups.
is my theory correct regarding my groups not being able to move because it's not on the network?
thanks in advance...
i have been trying to move my Node 1 group to Node B but it kept coming up with Error ID: 5005 (unable to move the group). i checked all the ownership of the resources and it has the proper Nodes listed. the Cluster wasn't in the middle of transfering resources, nor is Cluster Service paused, or stoped on both Node 1 and 2. the only thing i can think of is because the public NIC can not locate the DC where both Nodes are plugged into an isolated router to make the NICs look alive. the funny thing is that i can move Cluster Group between Node 1 and 2, but not my other two groups.
is my theory correct regarding my groups not being able to move because it's not on the network?
thanks in advance...