dhillster1476
Technical User
I have recently installed an IPO500 V2 (Version 9.0.600.979). It is equipped with Digital Station 8 Card (Bay1) and a Combo card (Bay2). I had upgraded it to 9.1.1.0 Build 10 but downgraded it back when I realized I needed an upgrade license.
Presently I have 2 (CO) central office lines connected via the combo card (Port 9-Line5 and Port 10- Line6). There is dial tone on both lines (when disconnected from IPO), the light on the ports are green when plugged in, the lines appear in IPO System Status as Idle. In Manager I can configure the line5 but when I click on lines 6,7 or 8 it reverts back to Line5.
I tried switching the lines on different ports but same result.
I suspect it may have something to do with the upgrade and subsequent downgrade.
I would appreciate any assistance in this matter.
Presently I have 2 (CO) central office lines connected via the combo card (Port 9-Line5 and Port 10- Line6). There is dial tone on both lines (when disconnected from IPO), the light on the ports are green when plugged in, the lines appear in IPO System Status as Idle. In Manager I can configure the line5 but when I click on lines 6,7 or 8 it reverts back to Line5.
I tried switching the lines on different ports but same result.
I suspect it may have something to do with the upgrade and subsequent downgrade.
I would appreciate any assistance in this matter.