UDP extension not alternatly routing...

[98Converter]

I have an extension (6020) that routes over ISDN (SDN with AT&T) trunk. We want to begin routing this over IP Trunks. We only have 5 members in the IP trunk group for testing. We have the ISDN trunk group as preference 2 in our route pattern, however once the IP trunk is busy - the call will not route ISDN.

I placed point two in the route pattern to route ISDN, but I keep getting a busy when it tries to route that way.


Pattern Number: 201 Pattern Name: IP To SITE 2
SCCAN? n Secure SIP? n
Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 6 1 200 3 n user
2: 4 0 617 0 n user

BCC VALUE TSC CA-TSC ITC BCIE Service/Feature BAND No. Numbering LAR
0 1 2 3 4 W Request Dgts Format
Subaddress
1: y y y y y n n rest none
2: y y y y y n n rest sdn none


15:22:18 active station 2536 cid 0x12aa
15:22:18 G711MU ssff ps:20 rn:1/1 10.2.110.2:2464 10.1.90.109:4780
15:22:20 dial 6020 route:UDP|AAR
15:22:20 term trunk-group 4 cid 0x12aa
15:22:20 dial 6020 route:UDP|AAR
15:22:20 route-pattern 201 preference 2 cid 0x12aa
15:22:20 seize trunk-group 4 member 5 cid 0x12aa
15:22:20 Calling Number & Name NO-CPNumber NO-CPName
15:22:20 Proceed trunk-group 4 member 5 cid 0x12aa
BUSY RIGHT HERE...
15:22:23 idle station 2536 cid 0x12aa

The call is normally sending 4 digits to AT&T cloud and they are inserting the Area code and NXX.

Thanks for any insight,
CJH

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[jnewbe]

check your insert and delete digs, make sure the far end has what your sending correctly.

 

[98Converter]

The far end is a Tie Trunk. Not sure of the setting if there is one to check on the PBX.

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.