UC360 collab video calls 1

[uccscott]

Hi, looking for any pointers in setting up UC360 Video conferencing.
at this point it is for a proof of Concept and only on the same LAN switch.

I have followed the Engineering and Admin guidelines for the relevant products and all appears correct.
Phones register and cameras are recognised no problem.
DSCP and L2P markings delivered by Option 43 as per the guideline.
L2 policies and classes mapped on the Cisco switches.

On a Video pod I can make Audio calls to an Audio pod and standard phone (predominantly 5320's);
or I can make Video calls and receive a video stream between Video units but they do not pass the Audio!

Any help appreciated

 

[Billz66]

make sure sip device capabilities is set to allow multiple m lines
if making calls via sip trunks they will also need that allowed on the sip peer
its the multiple m line setting that allows a sip call to add another stream of data

If I never did anything I'd never done before , I'd never do anything.....

and due to an endless stream of MiCollab , MiCC issues
Life would be simpler If only they tested products properly before releasing them .....

 

[uccscott]

Thanks for your help.
Multiple m-lines set on the SIP Device Capabilities but not the SIP Trunks, I'll follow that thread.